Condor’s Aluminum Signal Housings (Bungalows) and Cases can be custom built to any size and are constructed according to the industry standards using high grade, premium quality industrial aluminum. The interior contains rigid foam insulation, complete with aluminum foil vapor barrier.

The walls and floor are completely faced with painted plywood and the floor has two coats of acid resistant paint. The floor is lined with 3/16″ thick non slip rubber safety matting.

Standard Interior setup contains an electrical panel complete with circuit breakers as required for AC power circuits, exhaust fan with thermostat, fluorescent lighting fixtures with wall switch and duplex convenience receptacle. A fan driven heater can also be installed if required.

Bungalows are fitted with two doors. One for entry, and one for field cable entry and access to rear of faraday cage or low impedance ground plane.

Cases can be single or double door.

The floors are covered with 3/16″ thick non slip rubber safety matting which is corrosive resistant and electrically non conductive.

Bungalows are fitted with two separate doors, both doors swing out when facing the bungalow from outside. One door provides entrance to the bungalow and the other access to the rear of the main terminal board (Faraday Cage).

The lower portion of the front door is equipped with an air vent. Aluminum wire mesh covers the interior side of the vent. Both doors incorporate vandal- resistant latching assemblies.